WARNING:
JavaScript is turned OFF. None of the links on this concept map will
work until it is reactivated.
If you need help turning JavaScript On, click here.
This Concept Map, created with IHMC CmapTools, has information related to: Injector Area, Backpressure before Injector (V354) Functionality V354 creates a fixed restriction to achieve the needed backpressure before the injector or infuser., Injector Controls None, Holding tube and backpressure (PT330, V330) Functionality Typically ~60 to 65 PSI, Backpressure before Injector (V354) Functionality Typically ~85 to 90 PSI., Temperature Control (V344, TC344) Functionality V344 is the steam control valve, Injector Area Works with Temperature Control (V344, TC344), Holding tube and backpressure (PT330, V330) Controls V330is PID controlled based on PT330, Infusion Functionality Process flow always goes through the infuser vessel even when final heater is not active., Injector Area Works with Backpressure before Injector (V354), Temperature Control (V344, TC344) Purpose Final heater in the steam injector and steam infuser, Injector Purpose Raise product temperature by direct steam injection, Backpressure before Injector (V354) Functionality V354 works with the M2/M4 to assure steady flow leading to injector or infuser., Injector Area Works with Infusion, Holding tube and backpressure (PT330, V330) Functionality V330 creates a variable restriction to achieve the needed backpressure after the injector in the holding tube., Injector Functionality Steam only flows through the injector when the final heater is active, Backpressure before Injector (V354) Purpose Maintain required backpressure before injector and infuser, Injector Area Works with Holding tube and backpressure (PT330, V330), Infusion Purpose Raise product temperature by direct steam infusion, Holding tube and backpressure (PT330, V330) Controls V330 air pressure is modulated via an I/P converter., Injector Functionality Process flow always goes through the injector even when final heater is not active.